1-1

1.産品使用的最大工作溫度，最大功率等均依照規格書要求作業，不可超出規格書之範圍。

( Maximum service temperature and  maximum power  in application should not exceeds specification listed in  Product  Specification)

2.産品移動、安裝必須輕拿輕放，不可用力拉動。

(Much be handled with care when moving and installing the product)

3.外殼發生變形、氧化等現象時，不要使用，以免影響感溫精度。

(Product should not be used when deformed or rusty casing is observed on product

4.産品外觀發生變形、破損時，不可使用，以免影響電氣性能。

(Product should not be used when broken housing ,or excessive deformation on housing is observed)

5.在操作溫度範圍内，應盡量避免過于激烈的溫度變化。

(Avoid excessive  temperature fluctuation when operating the product in its operational temperature range)

6.不可施加過度振動的壓力。

( Do not apply excessive shock and vibration  on product)

7.避免過度拉伸、彎曲導線。

( Do not pull or bend the lead wire  excessively)

8. 不要使用在有腐蝕性氣體(CO2,NH3,Sox,Nox)超出指定的條件。

   不要使用在電解、鹽、酸、堿性和有機溶劑超出指定的條件。

   (Do not use in any ambient with  corrosiven gas (CO2,NH3,Sox,Nox)

   (Do not use in any ambient with electrolytic solution with brine,acid,alkaline and organic )|

9.盡可能避免使用在有水、高濕及其他帶腐蝕性的環境中

(Do not use in  environment with water.high moisture,and high corrosive solution)

10.通過負溫度系數溫度感測器的電流會引起元件自身發熱而産生測量誤差，因此需在使用前将此因素考慮在内
(Current throught NTC element will cause self-heating,and may affect the measurement)

11.此款産品屬表面平貼式感測溫，使用時需使底部平面充分受熱。

(This product belongs to surface appressed type sensor temperature, when using, need to make bottom plane fully and heating.)

1-2

如果有任何不清楚的地方,請咨詢到我們公司的銷售主管或工程師.

(If there is anything question and concerns, please contact to our  sales representative and engineer)